Ambirad VISION VSO Instructions d'exploitation télécharger pdf (Page 15)

Step 4 Withdraw the turbulators from the

appliance. Carefully noting their condition and

position. Replace turbulators if necessary.

Step 5 The turbulators should be cleaned with

a soft brush.

Step 6 If required the interior of the tubes can

then be cleaned using an industrial vacuum

cleaner or by using long poles and a scraper.

Step 7 Refit components.

3.9 Heat Exchanger Servicing

Step 1 Remove the flue connections.

Step 2 Slacken casing support screws and

remove heat exchanger from the radiant tube.

Step 3 Remove any dust and dirt from the heat

exchanger & refit.

3.10 Reflector Servicing

The condition of the reflectors should be noted.

If necessary the reflectors can be cleaned with a

mild detergent.

This can significantly improve the efficiency of

the appliance.

3.11 Inspection of Flue

The flue needs to be inspected and cleaned if

necessary or in accordance to the regulations of

the country that the appliance is installed.

3.12 Re-commissioning After Service

After servicing of the heater has been

undertaken, it will be necessary to

re-commission the heater as detailed in Section

2 of these instructions.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire